How Light Is Used To Create Images – 2

Note: This is the second in this series and has been updated since last year.

How Light Is Used To Create Images-2

by William Lulow

In the last article, we talked about MODIFYING light in order to create images. Today, we’ll talk about the various types of light modifying tools we can use. Since the simple reflector is limited in its ability to provide the kind of light necessary for good, commercial portraits, it needed to be changed. Over the years, photographers found that they still needed to direct light toward their subjects, but that light was much better if it was soft. So, they tried to figure out what could make the light soft. And, they discovered that a large light placed fairly close to their subjects would give a very pleasing light. Manufacturers of photographic lighting equipment began making very large reflectors that were able to take large bulbs. Today, these kinds of light fixtures are sometimes referred to as “beauty dishes.”

They are large, very broad reflectors that are also fairly shallow. (The one pictured above is only 22” in diameter. But some were quite a bit larger.) They were of the theatrical variety in that they often took a fair amount of electricity to run and became very hot to handle. But, the science of these lights, in terms of the effect they had on the light they produced, made for nice, soft light that could be used to create great portraits. THE LARGER THE LIGHT SOURCE, THE SOFTER THE LIGHTING EFFECT.  This is one of the main ideas for portrait photographers. They need large light sources in order to provide the kind of light required for commercial portraits. Of course, smaller reflectors had their purpose as well. Photographers began to use them to add accents to highlight certain aspects of their subjects or the backgrounds. As manufacturing practices improved, they found that they could duplicate the effect of beauty dishes quite nicely by using large umbrellas that were made with reflective material inside them. Light from a bulb had to travel to the umbrella, bounce off it and then travel the remaining distance to the subject. This served very nicely to soften the effect of the light.

This photographic umbrella has a diameter of roughly six feet! It also has a black backing which prevents light from escaping through the material which would greatly lessen its effect.

Here is my large, photographic umbrella in use at the studio:

I actually began with an umbrella I had made especially for portraits. I went to an umbrella manufacturer and asked if they could make one with twice the normal number of ribs, because I noticed that on commercially available photographic umbrellas, many had 8 ribs. This meant that the distance the fabric was stretched between ribs made a straight line. This was very unsightly when reflected in the catchlights of the subject’s eyes. I also wanted a rounder light source. So, they made me an umbrella with 16 ribs instead of the normal eight. Today, the umbrella shown here has the required number of ribs to make the light source appear round, and was commercially available. I guess they took my requirements into account! The next article will deal with modern uses of light modifiers.